News center

Latest productMORE>>

Enamel Thick Film Heater
Enamel Resistor
Thick Film Heater
Thick Film Heater

Application features of silicon rubber heating chip

Your current location: Home >> News >> Trade News

Application features of silicon rubber heating chip

Date of release:2018-08-30 Author: Click:

1. The heating plate using the electric heating device, it is necessary to pay attention to its continued use operating temperature should be less than 240 ℃, the instantaneous does not exceed 300 ℃.

2. The silica gel heating chip can work and bear pressure. Use auxiliary pressure plate to make it close to the hot surface. Outstanding thermal conductivity, temperature not to surpass 240 ℃ in the assignments section, the current density can be up to 3 w/c ㎡. We see a lot of shawl massagers, massage belts, backrest massagers and so on are made with non-woven fever piece. Non-woven fever piece only 3 to 5 mm, the thickness of the area from 10 cm to 4.0 ㎡, the work from 0.5 watts to several hundred watts, the highest working temperature of 150 ℃. It is an ideal heating element for the design of low temperature surface heating applications.


3. Zhang Tieshi device working conditions, to allow operating temperature is less than 150 ℃.

4. If the air dry condition, the data constraints of heat-resistant, its power density should be less than 1 W/c ㎡; Not continue working condition, the power density of 1.4 W/c ㎡.

5. The working voltage of the heating plate is selected according to the criteria of high power - high voltage and low power - low voltage. Special requirements can be listed out.

The address of this article:/en/news/405.html

Key word:

Recently browse:

Related products:

Related news:

National free consultation hotline:


Hot product  |  Main area: China
  • Service
  • number
  • Message
  • Online Service
    Please leave a message for us
    Please input the message here, and we will contact you as soon as possible.


    XML 地图 | Sitemap 地图